Konica Minolta bizhub C353 Service Manual page 424

Field Service Ver. 3.0 Jan. 2008
(2) Date & Time Setting
Functions • To set the data and time-of-day.
Use • Use to set or change the date and time-of-day.
Setting/ 1. Call the Service Mode to the screen.
Procedure 2. Touch [CS Remote Care].
3. Touch [Detail Setting] to access Date & Time Setting.
4. Enter the date (month, day and year), time-of-day, and the time zone from the 10-key
pad.
5. Touch [SET] to start the clock.
(3) RAM Clear
Functions • To clear the following data at the center
ID Code, Primary Setting, Date/Time Input (Time Zone), Software SW Setting and AT
Command.
Use • To be used for setting CS Remote Care.
• To be used for reset the every data of the center to default.
NOTE
• If RAM clear is selected during transmission, RAM clear processing will be
implemented at the time the transmission is completed regardless of whether
it is done properly or not.
Setting/ • The default setting is "Unset."
Procedure
(4) Communication Log Print
Functions • To print out the communication log.
Use • Use to output and use the communication log.
Setting/ 1. Call the Service Mode on the screen.
Procedure 2. Touch [CS Remote Care].
3. Touch [Detail Setting] to access communication log print.
4. Load tray 1 or bypass tray with A4S or 8
5. Press Start key to print out the communication log.
(5) Software Switch Setting
Functions • To change the CS Remote Care settings.
Use • To change the settings for CS Remote Care as necessary.
Setting/ • Refer to "Software SW setting for CS Remote Care" for the setting.
Procedure See P.371
(6) Response Time Out
Functions • It sets the intervals for resending e-mails when transmission error occurred.
• It can be set only when [E-Mail] is selected by System Setting.
Use • To use when changing the intervals for resending e-mails when transmission error
occurred.
Setting/ • The default setting is 60 minute.
Procedure
Set
1 /
"60 minute" (10 to 1440)
10. Service Mode
"Unset"
x 11 paper.
2
379