Konica Minolta bizhub C353 Service Manual page 818

Field Service Ver. 2.0 Jan. 2008
2.1.2 Replacing the feed roller
A. Periodically replaced parts/cycle
• Feed roller: Every 300,000 prints
NOTE
• Replace the separation roller assy, feed roller and pick-up roller at the same time.
B. Replacing procedure
1. Remove the rear right cover. (Remove the right lower cover for 4th row.)
See P.13
2. Remove the tray3. (Remove the tray4 from 4th row.)
3. Remove the paper separation roller mounting bracket assy.
See the procedures 1 to 3 in P.3 "Replacing the separation roller assy."
[1]
[2]
[1]
A093F2C002DA
[2]
A093F2C003DA
2. Periodical check
4. Disconnect the connector [1] and
remove the harness from two wire
saddles [2].
5. Remove four screws [1] and remove
the feed unit [2].
5