Konica Minolta bizhub C353 Service Manual page 790

Field Service Ver. 2.0 Jan. 2008
[1]
13. Touch [Exit] on the Service Mode screen.
14. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
* If the result is NG:
• Possible causes includes failure of the document width detection variable resistor, wrong
wiring to the volume and failure of the DFCB.
5. Touch [Max. Width].
6. Press the Start key.
7. OK is displayed when the adjustment
A01HF3E534DA
8. Narrow the width across the edge
A01HF3C002DA
9. Touch [Min. Width].
10. Press the Start key.
11. OK is displayed when the adjustment
12. Touch [END].
A01HF3E535DA
7. Mechanical adjustment
has been completed.
guides [1] by sliding them to the "B6"
position.
has been completed.
45