10. Service Mode
10.4.8
Exhaust Fan Stop Delay
Functions
• To set the period of time before the exhaust fan motor stops.
Use
• At the completion of a print job/image stabilization or at jam/malfunction, the fan
Setting/
• 0 to 15 (minutes) can be entered with the ten-key pad. (Default is 0.)
Procedure
NOTE
• When this setting is set to 0 (minute), the fan motor runs for 5 seconds before
10.4.9
LD adjustment
A. LD delay adjust.
Functions
1
• Not used.
Use
Setting/
• The default setting is 14.
Procedure
NOTE
• Do NOT change this setting from the default value.
358
1
motor rotating at full speed comes to a stop. The period of time before the fan motor
stops can be delayed so that ozone left around the PC drum can be discharged.
it stops.
Field Service Ver. 3.0 Jan. 2008