Data Capture - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 3.0 Jan. 2008
10.9.10

Data Capture

Functions • When an error occurs, it acquires the print job data in order to analyze the cause of
the error.
Use • When an error occurs, this will be used to analyze the cause of the error according to
the print job data.
Setting/ NOTE
• The following conditions are necessary for this function.
Procedure
When selecting [Security Setting] → [Security Details] → [Print Data Capture]
in Administrator Settings, [Allow] must be set.
The hard disk must be mounted to the machine.
When selecting [Administrator Settings] → [Network Settings] → [FTP Set-
tings], [FTP Server Settings: ON] must be set.
• This function is not available when the optional image controller IC-409 is
mounted.
1. Select [Service Mode] → [System 2], and touch [Data Capture]. Select [ON].
(While the Data Capture setting is [ON], the print job data from the PC will be stored
in the hard disk.)
NOTE
• The original offset value can be disabled to address image failure and other
problems caused by individual CCD performance difference.
2. Check the IP address of the machine.
3. Connect the PC (Windows) and the machine with ethernet cable.
4. Start the DOS command prompt of the PC, and specify the IP address of the
machine to start FTP.
5. Input the user name and the password.
User name: capture
Password: sysadm
10. Service Mode
4037F3E538DA
4037F3E539DA
399