Set Logout - Avaya P334T-ML User Manual

Chapter 6 CLI – Layer 2
• set intelligent-multicast
group-filtering-delay
time
• set security mode
• set arp-aging-interval
• set arp-tx-interval
• set welcome message
• set allowed managers
enabled/disabled
• set allowed managers
IP
• set psu type

set logout

The set logout command is used to set the number of minutes until the system
automatically disconnects an idle session.
The syntax for this command is:
set logout [timeout in minutes]
timeout
Output Example:
To set the number of minutes until the system disconnects an idle session
automatically:
P330-N# set logout 20
Sessions will be automatically logged out after 20 minutes of
idle time.
102
Sets the time delay before a filter is
applied to a specific group.
Enables or disables the stack's MAC
security.
Sets the ARP aging interval.
Sets the keep-alive interval.
Sets a welcome message to appear after
a reboot.
Enables/disables the Allowed Managers
feature.
Used to add or remove an IP address
from the allowed managers table.
Sets the main power supply type (AC/
DC) of the module.
Number of minutes (0 to 999) until the system automatically
disconnects an idle session. Setting the value to 0 disables the
automatic disconnection of idle sessions (default is 15 minutes).
Page 130
Page 130
Page 130
Page 131
Page 131
Page 132
Page 132
Page 132
Avaya P334T-ML User's Guide