Set Port Security; Set Cascading; Set Inband Vlan - Avaya P334T-ML User Manual

Chapter 6 CLI – Layer 2

set port security

Use the set port security command to enable MAC security on a port or a
range of ports at the module level. The port security is activated only after you
enable the secutity mode at the stack level using the set security mode
command.
Note: This command is not supported in the P330-ML switches. This command is
used to set port security for ports in other P330 switches in the stack.
The syntax for this command is:
set port security { enable | disable } [<module>[/<port>]]
enable | disable
module/port
Output Example:
P330-N> set port security enable 1/2
Port 1/2 secured.

set cascading

Use the set cascading command to enable or disable fault-trap sending for
unconnected cascading links. The default setting is disable.
The syntax for this command is:
set cascading{up|down}fault-monitoring {enable|disable}
<mod-num>
Output Example:
P330-N# set cascading down fault-monitoring enable 1
Module 1 cascading-down fault monitoring enabled.

set inband vlan

Use the set inband vlan command to set a value for the management vlan
(from 1 to 3071).
122
Set the port security enable or disable
The switch number/the port number
Avaya P334T-ML User's Guide