Table 2.2 Avaya P334T-Ml <- -> Select Buttons - Avaya P334T-ML User Manual

Chapter 2 Avaya P334T-ML Front and Rear Panels
Table 2.1
LED Name
FDX
FC
Hspd
LAG
Table 2.2
Description
Left/Right
Reset module
Reset stack
22
Avaya P334T-ML LED Descriptions (Continued)
Description
Full Duplex mode
Flow Control
High Speed
Link Aggregation
Group (Trunking)
Avaya P334T-ML <- -> Select buttons
Function
Individual – select LED function (see table above)
Press both right and left buttons together for approximately 2
seconds. All LEDs on module light up until buttons are
released.
Press both Right and Left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
LED Status
ON – Full duplex mode (ports 1-48)
OFF – Half duplex mode (ports 1-48)
Always ON for ports 51,52 (full-duplex mode
only)
OFF – No flow control.
ON – One of the three possible flow control
modes is enabled.
Note: FC LED for Gigabit Ethernet ports
reflect the last negotiated mode when
autonegotiation is enabled and the link is
down.
Ports 1-48
OFF: 10 Mbps
ON: 100 Mbps 1000 Mbps
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Ports 51,52
N/A
P334T-ML
User's Guide