Set Intermodule Port Redundancy - Avaya P334T-ML User Manual

Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
set boot bank <value>
value
Output Example:
P330-1(super)# set boot bank bank-a
Boot bank set to bank-a

set intermodule port redundancy

Use the set intermodule port redundancy command to define or delete the
stack's unique intermodule redundancy scheme. The defined scheme can be cleared
using the set intermodule port redundancy off command.
The syntax for this command is:
set intermodule port redundancy <module/prim-port> <module/
second-port> {on [<name>]}
module/prim-port
module/second-port
on
name
Output Example:
P330-N> set intermodule port redundancy 1/7 2/12 on backbone
backbone: port 2/12 is intermodule redundant to port 1/7
Note: You must disable Spanning Tree before you can enable redundancy.
Avaya P334T-ML User's Guidee
{bank-a | bank-b}
The primary port number
The secondary port number
Set the intermodule redundancy
The name of the fast redundancy (default is 'fast')
Chapter 6 CLI – Layer 2
119