Set Internal Buffering; Set Boot Bank - Avaya P334T-ML User Manual

Chapter 6 CLI – Layer 2
Note: You must disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Output Example:
P330-N# set port redundancy enable
All redundancy schemes are now enabled

set internal buffering

The set internal buffering command allows you to set the size (either
Maximum or Minimum) of the Receive (Rx) buffer allocated to each port of the
specified switch. This command is meaningless when any port of the switch is
operating with flow control ON.
Note: This command is not supported by the P330-ML switches and is used to set
the internal buffering value for the P330 modules in the stack.
The syntax for this command is:
set internal buffering <mod_num> {max|med|min}
max
med
min
Example:
P330-N> set internal buffering 1 max
Done.

set boot bank

Use the set boot bank command to configure the software bank from which the
switch will boot at the next boot process. This command should be issued separately
for each switch in the stack using the session command.
118
Sets the internal receive buffer to its maximum size.
Sets the internal receive buffer capacity dynamically
Sets the internal receive buffer to its minimum size (this is the
Default).
Avaya P334T-ML User's Guide