Ip Bootp-Dhcp Relay Command; Configure Mode; Interface Mode; Ip Bootp-Dhcp Server Command - Avaya P334T-ML User Manual

Chapter 7 CLI – Layer 3
BOOTP-DHCP Commands
Table 7.7
Command
ip bootp-dhcp relay
ip bootp-dhcp Server
ip bootp-dhcp network

Configure Mode

ip bootp-dhcp relay Command

Use the ip bootp-dhcp relay command to enable relaying of bootp and dhcp
requests to the bootp/dhcp server. The no form of this command disables bootp/
dhcp relay. The default state is: disabled.
The syntax for this command is:
[no] ip bootp-dhcp relay
Example:
To enable relaying of BOOTP and DHCP requests:
Router-N(configure)# ip bootp-dhcp relay
To disable relaying of bootp and dhcp requests:
Router-N(configure)# no ip bootp-dhcp relay

Interface Mode

ip bootp-dhcp server Command

Use the ip bootp-dhcp server command to add a bootp/dhcp server to
handle bootp/dhcp requests received by this interface. The no form of this
command removes the server. A maximum of two servers can be added to a single
interface.
The syntax for this command is:
ip bootp-dhcp server <ip-address>
ip-address
200
BOOTP-DHCP Commands
The IP address of the server.
Page
200
200
201
P334T-ML User's Guide