Ip Rip Send-Receive Command; Ip Rip Default-Route-Mode Command - Avaya P334T-ML User Manual

Chapter 7 CLI – Layer 3

ip rip send-receive Command

Use the ip rip send-receive command to set the RIP Send and Receive mode
on an interface. The default state is talk-listen.
The syntax for this command is:
ip rip send-receive <mode>[<default route metric>]
mode
default route metric
Example:
To set the RIP Send and Receive mode on the interface "marketing" to be listen-only:
Router-N(config-if:marketing)# ip rip send-receive talk listen

ip rip default-route-mode Command

Use the ip rip default-route-mode command to enable learning of the
default route received by the RIP protocol. The default state is talk-listen.
The syntax for this command is:
ip rip default-route-mode <mode>
The possible default route modes on an interface are:
talk-listen
talk-only
180
talk-listen - Set RIP to receive and transmit
updates on the interface.
talkdefault-listen - Set RIP to receive
updates on the interface and send only a default
route.
Integer value
Set RIP to send and receive default route updates on
the interface.
Set RIP to send but not receive default route updates
on the interface.
P334T-ML User's Guide