Cli - Layer 2; Chapter 6 Cli – Layer 2; User Level Commands - Avaya P334T-ML User Manual

Chapter 6
CLI – Layer 2
This chapter provides all the Layer 2 CLI commands, parameters and their default
values.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, you must type the desired command at the prompt and press
Enter.
Note: The terms "module" and "switch" are used interchangeably.

User Level Commands

This section describes all commands that are available from the User level.
Following is a table of the User Level commands and command groups (all
commands are also available at the higher levels).
• session
• terminal width
• terminal length
• clear screen
1
• show
• ping
• dir
1 This command corresponds to a group of commands and is shown in a
separate Table on Page 58.
Avaya P334T-ML User's Guide
Opens a session to another P330 switch, X330
ATM Access sub-module, X330 WAN Access
sub-module or G700 MGP.
Displays or sets the width of the terminal
display.
Display or set the length of the terminal
display.
Clears the current terminal display.
Shows the current switch parameters.
Sends ICMP echo request packets to another
node on the network.
Show files in the system.
Page 56
Page 56
Page 56
Page 57
Page 58
Page 57
Page 90
55