Ip Vrrp Primary Command; Ip Vrrp Override Addr Owner Command - Avaya P334T-ML User Manual

Chapter 7 CLI – Layer 3

Ip vrrp primary Command

Use the ip vrrp primary command to set the primary address that shall be
used as the source address of VRRP packets for the virtual router ID. Use the no
form of this command to return to the default primary address for the virtual router
instance. By default, the primary address is selected automatically by the device.
The syntax for this command is:
[no] ip vrrp <vr-id> primary <ip-address>
vr-id
ip-address
Example:
ip vrrp 1 primary 192.168.66.23

Ip vrrp override addr owner Command

Use the ip vrrp override addr owner command to accept packets
addressed to the IP address(es) associated with the virtual router, such as ICMP,
SNMP, and TELNET (if it is not the IP address owner). Use the no form of this
command to discard these packets.
The syntax for this command is:
[no] ip vrrp <vr-id> override addr owner
vr-id
Example:
Router-N(config-if:marketing)# ip vrrp 1 override addr owner
196
Virtual Router ID (1-255)
Primary IP address of the virtual router. This address
should be one of the router addresses on the VLAN.
Virtual Router ID (1-255)
P334T-ML User's Guide