System board and components
9.2.3
Replacing the UFM board
Field Replaceable Unit
(FRU)
Tools: combination pliers and flat nose pliers, Phillips PH1 / (+) No. 1 screw
driver
9.2.3.1
Preliminary steps
Perform the following procedures:
"Disabling SVOM boot watchdog functionality" on page 75
Ê
Ê Locate the desired server with the ID button.
"Shutting down the server node" on page 41
Ê
Ê If applicable, remove all external cables from the server node.
"Removing the server node from the Dual Node Cluster Server" on page 42
Ê
9.2.3.2
Removing the UFM
Ê Remove the UFM as described in section
page
194.
9.2.3.3
Re-installing the UFM
Ê Connect the UFM board to the system board and secure the UFM module
on the UFM spacer with the nylon screw as described in
board" on page
Destroying the defective UFM board
V
CAUTION!
The UFM board contains customer information (e.g. IP address, license
numbers). After replacing the UFM, hand the defective UFM board over
to the customer. If the customer requests disposal of the defective UFM
board, proceed as follows:
196
189.
Upgrade and Maintenance Manual
Hardware: 10 minutes
Software: 10 minutes
"Removing the UFM board" on
"Installing the UFM
CX272 S1