•
Enter Database Administration using the feature code
++++++++
"
show
•
Press [
]. The DB Item Select screen displays.
Program Pulse Dialing Break Time:
•
Input 03-05, then press [
show
•
Press [
]. This advances to Break Time.
chg
•
Press [
] to select the appropriate break time ratio (60/67).
next
•
Press [
] to advance to pulse dialing Inter-Digit Time.
chg
•
Press [
] to select the Pulse Dialing Inter-Digit Time.
next
•
Press [
] to advance to Tone Time.
chg
•
Press [
] to select the appropriate DTMF Tone Time (this time is also used for DTMF inter-digit timing).
•
Press
to return to the previous menu level or press
screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
•
Enter PC-DBA by typing "DX-80" at the DOS prompt in the PC-DBA working directory and then pressing «.
•
Press any key at the program title page (as it requests) to enter the Main Menu.
•
Select PC-DBA from the main menu.
•
Select Programming from the PC-DBA menu. Then press «.
•
Use ¢£¤¥ to highlight "Call Handling" and then press «.
•
Use ¢£¤¥ to highlight "Category 2" and then press «.
•
Use ¢£¤¥ to highlight "Break Time," "Inter-Digit" or "Tone Time."
•
Press « until the appropriate value displays.
•
When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: "Exit This Feature"; press "Y" for yes.
•
You will then be prompted to "Save Current Setting?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" to save changes.
•
If you press "Y" (yes), you will then be prompted "File Exists, Override?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" (yes) to continue with the save operation.
•
Press ° (escape) again to return to the Database Programming menu.
•
Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a "SEND" function has
been performed. Please refer to the Programming section of this manual to learn more about this procedure.
Touch Tone On/Off
Touch Tone On/Off can be used to customize a users telephone tactile response of dial pad key operation. At default
(factory setting), Touch Tone is ON. While ON, anytime the dial pad button/keys are pressed the telephone will emit a
subtle beep tone as an assurance that this button operation was successful. Since this confirmation may not always
be necessary, the tone can be turned off.
P7290 IMM
DX-80 I
M
NSTALLATION AND
AINTENANCE
." (Note: This eight-character password can be changed.)
save
]. This advances to Dialing Ratio.
3-219
M
03/01
ANUAL
!+*
and then enter the DB Admin password
to return to the DB Item Selection
!/1