Co Line Type Assignment - Comdial DX-80 Installation & Maintenance Manual

•
You will then be prompted to "Save Current Setting?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" to save changes.
•
If you press "Y" (yes), you will then be prompted "File Exists, Override?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
•
Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a "SEND" function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.

CO Line Type Assignment

Each CO line can be assigned as "PBX," "CO Line," "EMPTY," "CO DEV," or "PAGE." These designations provide for
the following possible CO Line circuit connections:
CO: CO type CO Line circuits are standard interface CO Lines that require no special handling for advanced system
features.
PBX: PBX Line type invokes system automatic operations for handling of PBX ports. When a programmed PBX
Trunk access code is dialed, the system is alerted that the user is accessing a telephone company facility to make a
network call. When this occurs, the system monitors digits dialed after the PBX access code and compares them
against the Allowed Digit Interval table in that station's Class of Service. The programmed PBX Trunk access code
also notifies the system that a pause should be inserted when re-dialing telephone numbers dialed on that CO line
beginning with the PBX access code. This operation applies for Speed Dial, Last Number Redial, Saved Number
Redial, Memo Pad, and Automatic Redial.
EMPTY: Assignment reserved for CO lines equipped on the system, but not connected to telephone company,
network facilities. The EMPTY type eliminates the CO Line from access by system features that automatically access
CO Line resources.
CO DEV: CO DEV type is provided to mark a CO Line circuit as being connected to special apparatus. This type
effectively removes the CO Line circuit from automatic access by system features while maintaining its direct
accessibility for the specific purpose of its connection. (Typical use would include connection of ancillary analog
intercom calling device.)
PAGE: PAGE type is provided to mark a CO Line circuit as being connected to special apparatus. This type
effectively removes the CO Line circuit from automatic access by system features while maintaining its direct
accessibility for the specific purpose of its connection. (Typical use would include connection of ancillary paging
equipment.)
Related Features
Class of Service – Station
Related Programming
CO Line - CO Line Type
Extension - Class of Service
Restriction - Toll Restriction
Default Settings
At default CO Line Type is set to "CO" for all CO Lines.
Programming Abstract
Program CO Line Type for each CO Line circuit according to its use requirement.
P7290 IMM
DX-80 I M
NSTALLATION AND AINTENANCE
3-80
M 03/01
ANUAL
External Paging