Intrusion - Extension/Co Line - Comdial DX-80 Installation & Maintenance Manual

Voice Announce
Forced Intercom Tone Ring
Operation – setup:
!98
1. While idle, press
!98
2. Press again to advance through each of the available modes.
Operation – receiving a call in VA-HF mode:
When your extension is idle an intercom call to your extension will alert you of the call with one tone burst.
The voice connection is then immediately established and you may respond to the calling extension without
lifting the handset.
Operation – receiving a call in VA-Privacy mode:
1. When your extension is idle an intercom call to your extension will alert you of the call with one tone burst.
The voice connection is then immediately established however the Mute function is automatically activated
at your extension. The calling extension voice announcement is heard over the speaker but the microphone
in your telephone is disabled.
2. You can:
a. Lift the handset to speak confidentially with the calling extension.
b. Press the
hands-free. (Using speakerphone mode.)
Operation – receiving a call in Tone mode:
1. When your extension is idle an intercom call to your extension will alert you of the call with a double-burst
tone which is repeated until you respond or until the call follows a Call Forward route.
2. You can:
a. Lift the handset to speak confidentially with the calling extension.
b. Press the
hands-free.
Conditions
a) Intercom calls to Digital Speakerphones selected for Voice Announce - Hands-free or Voice Announce -
Private are "logically" answered by the system at the called extension.
b) During Tone Ring, the red LED associated to the
c) If a Flexible Feature Button has been programmed with the Intercom Mode Selection Code (
LED associated to that button will indicate the current mode selection as follows:
•
Voice Announce – Hands-free, LED will light steady green.
•
Voice Announce – Privacy, LED will light steady red.
•
Tone Ringing Mode, LED will not light
Default Setting
All digital speakerphones are set to Voice Announce – Hands-free Reply mode.

Intrusion - Extension/CO Line

Intrusion allows the initiator to enter into an existing conversation when the initiator has been given the
privilege to do so via Extension programming ("Intrusion Active" = Y). This feature can be very effective for
service observing and any time that forcedly entering into a conversation on a CO Line or at another
extension may be required.
Intrusion can be invoked both on a busy CO Line and to a busy extension.
P7290 IMM
DX-80 I M
NSTALLATION AND AINTENANCE
Voice Announce - Busy Extension Hands-free Reply
. Confirmation Tone is heard and the display indicates the new mode set:
VA-PRIVACY MODE
VA-HF MODE
TONE RING MODE
button to deactivate the Mute feature and speak with the calling extension
button to activate the speakerphone and speak with the calling extension
3-157
M 03/01
ANUAL
button will flash.
!98
) the