Reauthenticate Port(S) - D-Link xStack User Manual

xStack

Reauthenticate Port(s)

This window allows reauthentication of a port or group of ports by using the pull-down menus From and To and clicking Apply.
The Reauthenticate Port Table displays the current status of the reauthenticated port(s) once Apply has been clicked.
To view this window, click Security > 802.1X > Reauthenticate Port(s), as shown below.
To reauthenticate ports for the MAC side of 802.1X, the user must first enable 802.1X by MAC address in the DGS-3400 Web
Management Tool window.
Click Security > 802.1X > Reauthenticate Port(s) as shown below:
Figure 6 - 26 Reauthenticate Port(s) window (MAC-based 802.1X)
To reauthenticate ports, first choose the switch in the switch stack by using the pull-down menu and then choose the range of ports
in the From and To field. Then the user must specify the MAC address to be reauthenticated by entering it into the MAC Address
field and ticking the corresponding check box. To begin the reauthentication, click Apply.
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
NOTE: The user must first globally enable 802.1X in the DGS-3400 Web
Management Tool window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1X.
Figure 6 - 25 Reauthenticate Port window
NOTE: The user must first globally enable 802.1X in the DGS-3400 Web
Management Tool window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1X.
242