Reauthenticate Port(S) - D-Link DGS-3600 Series User Manual

This window displays the following information:
Parameter Description
From and To Select ports to be initialized.
Port A read-only field indicating a port on the Switch.
MAC Address The MAC address of the Switch connected to the corresponding port, if any.
Auth PAE State The Authenticator PAE State will display one of the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth, ForceUnauth, and N/A.
Backend State The Backend Authentication State will display one of the following: Request, Response,
Success, Fail, Timeout, Idle, Initialize, and N/A.
Port Status The status of the controlled port can be Authorized, Unauthorized, or N/A.

Reauthenticate Port(s)

This window allows reauthentication of a port or group of ports by using the pull-down menus From and To and clicking Apply.
The Reauthenticate Port Table displays the current status of the reauthenticated port(s) once Apply has been clicked.
Click Security > 802.1x > Reauthenticate Port(s) to open the Reauthenticate Port(s) window:
To reauthenticate ports for the MAC side of 802.1x, the user must first enable 802.1x by MAC address in the DGS-3600 Web
Management Tool window. Click Security > 802.1x > Reauthenticate Port(s) to open the following window:
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
NOTE: The user must first globally enable 802.1x in the DGS-3600 Web
Management Tool window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1x.
Figure 11- 1 . Reauthenticate Port window 9
NOTE: The user must first globally enable 802.1x in the DGS-3600 Web
Management Tool window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1x.
282