D-Link xStack User Manual page 200

xStack
The window shown below is the Access Profile Configuration window for Packet Content Mask:
Figure 5 - 9 Access Profile Configuration window (Packet Content Mask)
This window will aid the user in configuring the Switch to mask packet headers beginning with the offset value specified. The
following fields are used to configure the Packet Content Mask:
Parameter Description
Profile ID (1-6) Type in a unique identifier number for this profile set. This value can be set from 1 to 6.
Type Select profile based on Ethernet (MAC Address), IP address, packet content mask or IPv6. This
will change the menu according to the requirements for the type of profile.
The offset field is used to examine the packet header which is divided up into four "chunks" where
Offset
each chunk represents 4 bytes. Values within the packet header chunk to be identified are to be
marked in hexadecimal form in the "mask" field. The following table will help you identify the bytes
in the respective chunks.
chunk0 chunk1
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 5 - 8 Access Profile Entry Display for IPv6
•
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
•
Select IP to instruct the Switch to examine the IP address in each frame's header.
•
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
•
Select IPv6 to instruct the Switch to examine the IPv6 part of each packet header.
chunk2........ chunk29 chunk30 chunk31
189