D-Link xStack User Manual page 55

xStack
The following fields can be configured or viewed:
Parameter
Interface Name
Neighbor IPv6
Address
State
Neighbor
Link Layer Address
Interface
State
To remove an entry, click the corresponding Delete button. To completely clear the IPv6 Neighbor Settings, click the Clear All
button. To add a new entry, click the Add button, revealing the following window to configure:
The following fields can be set or viewed:
Parameter
Interface Name
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 2 - 38 IPv6 Neighbor Settings window
Description
Enter the interface name of the IPv6 neighbor you wish to find.
Enter the neighbor IPv6 address of the entry you wish to find.
To find or delete specific entries use the pull-down menu to select either Static or Dynamic.
Static – Select Static to view all statically entered IPv6 neighbors on the Switch.
Dynamic – Select Dynamic to view all dynamically configured neighbor devices which are IPv6
neighbors of the IP interface previously created.
Displays the IPv6 address of the neighbor device.
Displays the MAC address of the corresponding IPv6 device.
Displays the Interface name associated with this IPv6 address.
Displays the running state of the corresponding IPv6 neighbor. The user may see six possible
entries in this field, which are Incomplete, Stale, Probe, Reachable, Delay or Static.
Figure 2 - 39 IPv6 Neighbor Settings – Add window
Description
Enter the name of the Interface associated with this entry, if any. The Interface field is
used for addresses on the link-local network. It is recommended that the user enter the
IPv6 Neighbor Settings
44