D-Link xStack User Manual page 98

xStack
The following fields are displayed:
Parameter
Port
Analyzer Server ID
Polling Interval
(sec)
Modify
Delete
To delete all the entries in the table click the Clear All button. To add a new sFlow Counter Poller setting, click the Add button
which will display the following window to be configured.
The following fields may be set:
Parameter
Unit
From...To
Analyzer Server ID
(1-4)
Polling Interval (20-
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 2 - 95 sFlow Counter Poller Settings window
Description
Displays the port from which packet counter samples are being taken.
Displays the ID of the Analyzer Server where datagrams, containing the packet counter polling
information taken using this polling mechanism, will be sent.
The Polling Interval displayed here, is measured in seconds and will take a poll of the IF
counters for the corresponding port, every time the interval reaches 0 seconds.
Click this button to modify the settings for this entry. The sFlow Sampler Settings Edit
window will be produced for the user to configure.
Click the corresponding
Figure 2 - 96 sFlow Counter Poller Add window
Description
Select the unit you wish to configure.
Choose the beginning and ending range of ports to be configured for counter polling.
Enter the previously configured Analyzer Server ID to state the device that will be receiving
datagrams from the Switch. These datagrams will include the counter poller information taken
using the polling mechanism configured here.
Users may configure the Polling Interval here. The switch will take a poll of the IF counters
button of the entry to be deleted.
87