D-Link xStack User Manual page 209

xStack
default quality of service or real time service packets.
The user may specify an IP address mask for the source IPv6 address by entering the IP
Source IPv6
Address address mask, in hex form.
Destination IPv6 The user may specify an IP address mask for the destination IPv6 address by and entering the
Address IP address mask, in hex form.
Port The Access Rule may be configured on a per-port basis by entering the port number of the
switch in the switch stack into this field. When a range of ports is to be configured, the Auto
Assign check box MUST be clicked in the Access ID field of this window. If not, the user will be
presented with an error message and the access rule will not be configured. The port list is
specified by listing the lowest switch number and the beginning port number on that switch,
separated by a colon. Then the highest switch number and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3 - 2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4
− in numerical order. Entering all will denote all ports on the Switch.
Rx Rate Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the
following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1- 156249 or No Limit. The default
setting is No Limit.
Time Range Click the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Counter Tick the check box and use the pull-down menu to employ the Counter that will count the packets
identified with this rule. Users must note that if the Counter is employed in the ACL Flow Meter
function, the Counter will automatically be disabled here, regardless of this setting.
To view the settings of a previously correctly configured rule, click
window:
The following window is the Access Rule table for Packet Content.
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 5 - 19 Access Rule Display window (IPv6)
in the Access Rule Table window to view the following
198