Vlan Commands - D-Link xStack DGS-3300 User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
The xStack DGS/DXS-3300 series now incorporates protocol-based VLANs. This standard, defined by the IEEE 802.1v
standard maps packets to protocol-defined VLANs by examining the type octet within the packet header to discover the type of
protocol associated with it. After assessing the protocol, the Switch will forward the packets to all ports within the protocol-
assigned VLAN. This feature will benefit the administrator by better balancing load sharing and enhancing traffic classification.
The Switch supports fifteen (15) pre-defined protocols for configuring protocol-based VLANs. The user may also choose a
protocol that is not one of the fifteen defined protocols by properly configuring the userDefined protocol VLAN. The supported
protocols for the protocol VLAN function on this Switch include IP, IPX, DEC, DEC LAT, SNAP, NetBIOS, AppleTalk, XNS,
SNA, IPv6, RARP and VINES.
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create vlan
delete vlan
config vlan
config vlan
config gvrp
enable gvrp
disable gvrp
show vlan
show gvrp
Each command is listed, in detail, in the following sections.
Parameters
<vlan_name 32> {tag <vlanid 2-4094> | {type {1q_vlan
{advertisement} | [protocol-ip | protocol-ipx802dot3 | protocol-
ipx802dot2 | protocol-ipxSnap | protocol-ipxEthernet2 | protocol-
appleTalk | protocol-decLat | protocol-decOther | protocol-
sna802dot2 | protocol-snaEthernet2 | protocol-netBios | protocol-
xns | protocol-vines | protocol-ipV6 | protocol-userDefined
<hex0x0-0xffff> encap [ethernet | llc | snap | all] | protocol-rarp]}}
<vlan_name 32>
<vlan_name 32> {[add [tagged | untagged | forbidden] <portlist> |
advertisement [enable | disable]}
<vlan_name 32> delete <portlist>
[<portlist> | all] {state [enable | disable] | ingress_checking [enable
| disable] | acceptable_frame [tagged_only | admit_all] | pvid
<vlanid 1-4094>}
{<vlan_name 32>}
{<portlist>}
NOTE: A specific protocol VLAN and a user defined protocol VLAN with
the same encapsulation protocol cannot coexist and will result in a Fail!
Message. (For example, if a user creates an Ethernet2 protocol VLAN, the
user can not create a userDefined protocol VLAN with an Ethernet
encapsulation)
116
15
VLAN C
OMMANDS