Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
traceroute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To trace the routed path between the Switch and 10.48.74.121.
DGS-3324SRi:4#traceroute 10.48.74.121 p r o b e 3
Command: traceroute 10.48.74.121 p r o b e 3
1 <10ms 10.254.254.251
2 <10ms 10.55.25.35
3 <10ms 10.22.35.1
DGS-3324SRi:4#
Used to trace the routed path between the Switch and a destination
endstation.
traceroute <ipaddr> {ttl <value 1-60> | port <value 30000-64900>
| timeout <sec 1-65535> | probe <value <1-9>}
The traceroute command will trace a route between the Switch and
a give host on the network.
<ipaddr> - Specifies the IP address of the host.
ttl <value 1-60> - The time to live value of the trace route request.
This is the maximum number of routers the traceroute command will
cross while seeking the network path between two devices.
port <value 30000-64900> - The port number. Must be above
1024.The value range is from 30000 to 64900.
timeout <sec 1-65535> - Defines the time-out period while waiting
for a response from the remote device. The user may choose an
entry between 1 and 65535 seconds.
probe <value 1-9> - The probe value is the number of times the
Switch will send probe packets to the next hop on the intended
traceroute path. The default is 1.
None.
59
Advertisement
Table of Contents
