D-Link xStack DGS-3300 User Manual page 100

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
DGS-3324SRi:4#show ipfdb
Command: show ipfdb
Interface
------------
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
config fdb destination_hit
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch to be destination hit enabled:
IP Address
---------------
10.0.0.1
10.0.0.2
10.0.0.3
10.0.0.4
10.0.0.7
10.0.0.30
10.0.34.1
10.0.51.1
10.0.58.4
10.0.85.168
10.1.1.1
10.1.1.99
10.1.1.101
10.1.1.102
10.1.1.103
10.1.1.152
10.1.1.157
10.1.1.161
10.1.1.162
10.1.1.163
To set the Switch for the FDB destination hit function.
config fdb destination_hit [enable | disable]
This command will allow the user to enable the Switch as a
destination hit bridge. This destination hit function will keep FDB
entries learned in the forwarding database table from aging out.
When a packet with a destination MAC address is received by the
Switch, the packet will refresh the MAC address in the forwarding
database table once a match has been made, so that it will not age
out.
[enable | disable] – Used to enable or disable the Switch to be
destination hit ready.
Only administrator-level users can issue this command.
DGS-3324SRi:4#config fdb destination_hit enable
Command: config fdb destination_hit enable
Success.
DGS-3324SRi:4#
Port Learned
------ ------------
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
1:13 Dynamic
97