Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config vrrp ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the authentication type for a VRRP entry:
DGS-3324SRi:4#config vrrp ipif Trinity authtype simple authdata tomato
Command: config vrrp ipif Trinity authtype simple authdata tomato
Success.
DGS-3324SRi:4#
DGS-3324SRi:4#config vrrp vrid 1 ipif Trinity state enable
priority 100 advertisement_interval 2
Command: config vrrp vrid 1 ipif Trinity state enable
priority 100 advertisement_interval 2
Success.
DGS-3324SRi:4#
To configure the authentication type for the VRRP routers of an IP
interface.
config vrrp ipif <ipif_name 12> [authtype [none | simple
authdata <string 8> | ip authdata <string 16>]
This command is used to set the authentication type for the VRRP
routers of an IP interface.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface for which to configure the VRRP entry. This IP interface
must be assigned to a VLAN on the Switch.
authtype – Specifies the type of authentication used. The authtype
must be consistent with all routers participating within the VRRP
group. The user may choose between:
•
none – Entering this parameter indicates that VRRP protocol
exchanges will not be authenticated.
•
simple authdata <string 8> - This parameter, along with an
alphanumeric string of no more than eight characters, to set a
simple password for comparing VRRP message packets
received by a router. If the two passwords are not exactly the
same, the packet will be dropped.
•
ip authdata <string 16> - This parameter will require the user to
set an alphanumeric authentication string of no more than 16
characters to generate a MD5 message digest for
authentication in comparing VRRP messages received by the
router. If the two values are inconsistent, the packet will be
dropped.
Only administrator-level users can issue this command.
275
Advertisement
Table of Contents
