D-Link xStack DGS-3300 User Manual page 206

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
DGS-3324SRi:4#config 802.1x auth_parameter ports 1:1 – 1:20 direction both
Command: config 802.1x auth_parameter ports 1:1 – 1:20 direction both
Success.
DGS-3324SRi:4#
config 802.1x auth_protocol
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the authentication protocol on the Switch:
DGS-3324SRi:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
DGS-3324SRi:4#
config 802.1x init
Purpose
Syntax
Description
Used to configure the 802.1x authentication protocol on the
Switch.
config 802.1x auth_protocol [local | radius_eap]
The config 802.1x auth_protocol command enables
configuration of the authentication protocol.
[local | radius_eap] – Specify the type of authentication protocol
desired.
Only administrator-level users can issue this command.
Used to initialize the 802.1x function on a range of ports.
config 802.1x init [port_based ports [<portlist>| all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>]
The config 802.1x init command is used to immediately initialize
the 802.1x functions on a specified range of ports or for specified
MAC addresses operating from a specified range of ports.
203