D-Link xStack DGS-3300 User Manual page 111

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config 802.1p default_priority
Restrictions
Example usage:
To configure 802.1p default priority on the Switch:
DGS-3324SRi:4#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DGS-3324SRi:4#
show 802.1 default_priority
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current 802.1p default priority configuration on the Switch:
DGS-3324SRi:4# show 802.1p default_priority
Command: show 802.1p default_priority
Port
-------
1:1
1:2
1:3
1:4
1:5
1:6
1:7
1:8
1:9
1:10
1:11
1:12
1:13
Only administrator-level users can issue this command.
Used to display the currently configured 802.1p priority tags that
will be assigned to incoming, untagged packets before being
forwarded to its destination.
show 802.1p default_priority {<portlist>}
The show 802.1p default_priority command displays the
currently configured 802.1p priority tag that will be assigned to an
incoming, untagged packet before being forwarded to its
destination.
<portlist> − Specifies a port or range of ports to be viewed. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
None.
Priority
-----------
0
0
0
0
0
0
0
0
0
0
0
0
0
108