D-Link xStack DGS-3300 User Manual page 287

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
create route redistribute dst rip src
Parameters
Restrictions
Routing information source − OSPF and the Static Route table. Routing information will be redistributed to RIP. The following
table lists the allowed values for the routing metrics and the types (or forms) of the routing information that will be redistributed.
Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the combination type_1
type_2 is functionally equivalent to external. Entering the combination internal external is functionally equivalent to all.
Entering the metric 0 specifies transparency.
Example Usage:
To add route redistribution settings:
DGS-3324SRi:4#create route redistribute dst rip src ospf all metric 2
Command: create route redistribute dst rip src ospf all metric 2
Success.
DGS-3324SRi:4#
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
•
all – Specifies both internal an external.
•
internal – Specifies the internal protocol of the source device.
•
external - Specifies the external protocol of the source device.
•
type_1 - Calculates the metric (for RIP to OSPF) by adding the
destination's interface cost to the metric entered in the Metric
field.
•
type_2 - Uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
•
inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.
•
inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a HOP Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Route Source Metric
OSPF 0 to 16
Static 0 to 16
Type
all
type_1
type_2
inter+e1
inter+e2
external
internal
not applicable
284