D-Link xStack DGS-3300 User Manual page 49

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
create trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the trusted host:
DGS-3324SRi:4#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DGS-3324SRi:4#
show trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
DGS-3324SRi:4#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version
Name/SNMPv3 User Name
--------------- --------------------- ------------------------------
10.48.76.23 V2c
10.48.74.100 V3
Total Entries: 2
DGS-3324SRi:4#
Used to create the trusted host.
create trusted_host <ipaddr>
The create trusted_host command creates the trusted host.
The Switch allows specification up to four IP addresses that are
allowed to manage the Switch via in-band SNMP or TELNET
based management software. These IP addresses must be
members of the Management VLAN. If no IP addresses are
specified, then there is nothing to prevent any IP address from
accessing the Switch, provided the user knows the Username
and Password.
<ipaddr> − The IP address of the trusted host.
Only administrator-level users can issue this command.
Used to display a list of trusted hosts entered on the Switch using
the create trusted_host command above.
show trusted_host
This command is used to display a list of trusted hosts entered on
the Switch using the create trusted_host command above.
None.
None.
Community
private
authpriv public
46