Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config 802.1x init
Parameters
Restrictions
Example usage:
To initialize the authentication state machine of some or all:
DGS-3324SRi:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DGS-3324SRi:4#
port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization
can then be specified.
ports <portlist> − Specifies a range of ports. The port list
is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the Switch.
mac_based - This instructs the Switch to initialize 802.1x functions
based on the MAC address of a device on a specific port or range
of ports. MAC address approved for initialization can then be
specified.
ports <portlist> − Specifies a range of ports. The port list
is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Specifies the MAC address of the
client to be added.
Only administrator-level users can issue this command.
204
Advertisement
Table of Contents
