Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show mac_notification ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display all port's MAC address table notification status settings:
DGS-3324SRi:4#show mac_notification ports
Command: show mac_notification ports
Port # MAC Address Table Notification State
------
1:1
1:2
1:3
1:4
1:5
1:6
1:7
1:8
1:9
1:10
1:11
1:12
1:13
1:14
1:15
1:16
1:17
1:18
1:19
1:20
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
Used to display the Switch's MAC address table notification status
settings.
show mac_notification ports <portlist>
This command is used to display the Switch's MAC address table
notification status settings.
<portlist> - Specify a port or group of ports to be viewed. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
Entering this command without the parameter will display the MAC
notification table for all ports.
None
------------------------------------
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
154
Advertisement
Table of Contents
