D-Link xStack DGS-3300 User Manual page 342

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To display OSPF area aggregation settings:
DGS-3324SRi:4#show ospf aggregation
Command: show ospf aggregation
OSPF Area Aggregation Settings
Area ID
------------ ---------------------
10.1.1.1
10.1.1.1
Total Entries: 2
DGS-3324SRi:4#
show ospf lsdb
Purpose
Syntax
Description
Parameters
Restrictions
Used to display the current OSPF area aggregation settings.
show ospf aggregation {<area_id>}
This command will display the current OSPF area aggregation
settings.
<area_id> − Enter this parameter to view this table by a specific
OSPF area ID.
None.
Aggregated LSDB
Network Address Type
--------------
10.0.0.0/8 Summary
20.2.0.0/16 Summary
Used to display the OSPF Link State Database (LSDB).
show ospf lsdb {area_id <area_id> | advertise_router
<ipaddr> | type [rtrlink | netlink | summary | assummary |
asextlink]}
This command will display the current OSPF Link State Database
(LSDB).
area_id <area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
advertise_router <ipaddr> − The router ID of the advertising router.
type [rtrlink | netlink | summary | assummary | asextlink] − The type
of link.
None.
Advertise
-------------
Enabled
Enabled
339