Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config authen parameter attempt
Parameters
Restrictions
Example usage:
To set the maximum number of authentication attempts at 5:
DGS-3324SRi:4#config authen parameter attempt 5
Command: config authen parameter attempt 5
Success.
DGS-3324SRi:4#
show authen parameter
Purpose
Syntax
Description
Parameters
Restrictions
DGS-3324SRi:4#show authen parameter
Command: show authen parameter
Response timeout: 60 seconds
User attempts
DGS-3324SRi:4#
enable admin
Purpose
Syntax
Description
parameter attempt <int 1-255> - Set the maximum number of
attempts the user may try to become authenticated by the Switch,
before being locked out. The default setting is 3 attempts.
Only administrator-level users can issue this command.
Used to display the authentication parameters currently configured
on the Switch.
show authen parameter
This command will display the authentication parameters currently
configured on the Switch, including the response timeout and user
authentication attempts.
This command will display the following fields:
Response timeout – The configured time allotted for the Switch to
wait for a response of authentication from the user attempting to log
in from the command line interface or telnet interface.
User attempts – The maximum number of attempts the user may try
to become authenticated by the Switch, before being locked out.
None.
None.
: 5
Used to promote user level privileges to administrator level privileges
enable admin
This command is for users who have logged on to the Switch on the
normal user level, to become promoted to the administrator level.
After logging on to the Switch users, will have only user level
privileges. To gain access to administrator level privileges, the user
176
Advertisement
Table of Contents
