Vlan Commands - D-Link DES-1210-52/ME Cli Reference Manual

The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create vlan
delete vlan
config vlan
config gvrp
config gvrp timer
enable gvrp
disable gvrp
show vlan
create
dot1v_protocol_group
group_id <id 1-16>
config
dot1v_protocol_group
delete
dot1v_protocol_group
show
dot1v_protocol_group
config port dot1v ports
all
show port dot1v
show gvrp
show gvrp timer
enable vlan_trunk
disable vlan_trunk
show vlan_trunk
config vlan_trunk ports
enable asymmetric_
vlan
disable
asymmetric_vlan
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Parameter
<string 32> tag <int 2-4094> type_1q_vlan_advertisement
[<vlan_name 32> | vlanid <vidlist >]
[<vlan_name 32> | vlanid <vlanid 1-4094>] [[add [tagged | untagged | forbidden] |
delete ] [<portlist> | name <vlan_name 32>] {advertisement [enable | disable]}
[state [enable | disable] | ingress_checking [enable | disable] | acceptable_frame
[Tagged_Only | All_Frames] | pvid <vlanid 1-4094>]
[join_timer <sec 100-100000> | leave_timer <sec 100-100000> | leave-all_timer
<sec 100-100000>]
{<vlan_name 32> | vlanid <vidlist> | ports <portlist>}
{group_name <name 32>}
[group_id <id 1-16> | group_name <name 32>] [add | delete] protocol [ethernet_2
<hex 0x0-0xffff> | ieee802.3_snap <hex 0x0-0xffff>]
[group_id <id 1-16> | group_name <name 32> | all]
{group_id <id 1-16> | group_name <name 32>}
[add | delete] protocol_group [group_name <name 32> | group_id <id 1-16>]
[vlan <vlan_name 32> | vlanid <id 1-4094>]
{ports <portlist>}
{<portlist>}
[<portlist> | all] state [enable | disable]

VLAN COMMANDS

213
28