D-Link xStack DGS-3300 User Manual page 209

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config radius add
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the RADIUS server communication settings:
DGS-3324SRi:4#config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DGS-3324SRi:4#
config radius delete
Purpose
Syntax
Description
Parameters
Restrictions
Used to add a new RADIUS server.
config radius add <server_index 1-3> <server_ip> key
<passwd 32> [default | {auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535>}]
The config radius add command is used to add RADIUS
servers to the Switch.
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server
settings can be entered on the Switch. The lowest index number
will have a higher authenticative priority
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
<passwd 32> − The shared-secret key used by the
RADIUS server and the Switch. Up to 32 characters can be
used.
default − Uses the default UDP port number in both the
"auth_port" and "acct_port" settings.
auth_port <udp_port_number> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number> − The UDP port number for
accounting requests. The default is 1813.
Only administrator-level users can issue this command.
Used to delete a previously entered RADIUS server configuration.
config radius delete <server_index 1-3>
The config radius delete command is used to delete a previously
entered RADIUS server configuration.
<server_index 1-3> − A number identifying the current set of
RADIUS server settings delete. Up to 3 groups of RADIUS server
settings can be entered on the Switch.
Only administrator-level users can issue this command.
206