D-Link xStack DGS-3300 User Manual page 76

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config syslog host all
Restrictions
Example usage:
To configure all syslog hosts:
delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
state [enable | disable] − Allows the sending of syslog messages to
the remote host, specified above, to be enabled and disabled.
Only administrator-level users can issue this command.
DGS-3324SRi:4#config syslog host all severity all
Command: config syslog host all severity all
Success.
DGS-3324SRi:4##config syslog host all facility local0
Command: config syslog host all facility local0
Success
DGS-3324SRi:4# config syslog host all udp_port 6000
Command: config syslog host all udp_port 6000
Success.
DGS-3324SRi:4# config syslog host all ipaddress 10.44.67.8
Command: config syslog host all ipaddress 10.44.67.8
Success.
DGS-3324SRi:4# config syslog host all state enable
Command: config syslog host all state enable
Success.
DGS-3324SRi:4#
Used to remove a syslog host, that has been previously
configured, from the Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command is used to remove a syslog
host that has been previously configured from the Switch.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
all − Specifies that all syslog hosts will be deleted.
Only administrator-level users can issue this command.
73