Vlan Commands - D-Link DES-1210-28/ME Reference Manual

The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create vlan
delete vlan
config vlan
config gvrp
config pvid
config gvrp timer
enable gvrp
disable gvrp
show vlan
show gvrp
show gvrp timer
enable vlan_trunk
disable vlan_trunk
show vlan_trunk
config vlan_trunk ports
enable asymmetric_
vlan
disable
asymmetric_vlan
show asymmetric_vlan
enable management
vlan
disable management
vlan
config management
vlan
show management
vlan
Each command is listed in detail, as follows:
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<string 20> {tag <int 2-4094> | type_1q_vlan_advertisement}
[<vlan_name 20> | vlanid <int 2-4094>]
[<vlan_name 20> | vlanid <vlanid 1-4094>] [[add [tagged | untagged | forbidden] |
delete ] <portlist> {advertisement [enable | disable]}
[<portlist> | all] state [enable | disable] { ingress_checking [enable | disable] |
acceptable_frame [Tagged_Only | All_Frames] | pvid <vlanid 1-4094>}
<int 1-4094> ports <portlist>
[join_timer <sec 10-100000> | leave_timer <sec 10-100000> | leave-all_timer
<sec 10-100000>]
{<int 1-4094>}
{<portlist>}
[<portlist> | all] state [enable | disable]
<string 32>

VLAN COMMANDS

159
24 24 24 24