D-Link xStack DGS-3300 User Manual page 65

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show error ports
Parameters
Restrictions
Example usage:
To display the errors of the port 3 of module 1:
DGS-3324SRi:4#show errors ports 1:3
Command: show errors ports 1:3
CRC Error
Undersize
Oversize
Fragment
Jabber
Drop Pkts
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show utilization
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the port utilization statistics:
<portlist> − Specifies a range of ports to be displayed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash.
For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical
order.
None.
RX Frames
---------------
19 Excessive Deferral
0 CRC Error
0 Late Collision
0 Excessive Collision
11 Single Collision
20837 Collision
Used to display real-time port and CPU utilization statistics.
show utilization [ports | cpu]
This command will display the real-time port and CPU utilization
statistics for the Switch.
cpu – Entering this parameter will display the current CPU
utilization of the Switch, as a percentage.
ports - Entering this parameter will display the current utilization
of all ports on the Switch.
None.
62
TX Frames
----------------
0
0
0
0
0
0