D-Link xStack DGS-3300 User Manual page 61

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
DGS-3324SRi:4#show firmware information
Command: show firmware information
Box ID Version
--- -- --------
1 *1 4.00-B02
1 2 3.00-B13
'*' means boot up firmware
(R) means firmware update thru SerialPort (RS232)
(T) means firmware update thru TELNET
(S) means firmware update thru SNMP
(W) means firmware update thru WEB
(SIM) means firmware update thru Single IP Management
DGS-3324SRi:4#
ping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To ping the IP address 10.48.74.121 four times:
DGS-3324SRi:4#ping 10.48.74.121 times 4
Command: ping 10.48.74.121
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Ping statistics for 10.48.74.121
Packets: Sent =4, Received =4, Lost =0
DGS-3324SRi:4#
Size(B) Update Time
------- -------------------
2360471 00000 days 00:00:00
1052372 00000 days 00:00:56
Used to test the connectivity between network devices.
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
The ping command sends Internet Control Message Protocol
(ICMP) echo messages to a remote IP address. The remote IP
address will then "echo" or return the message. This is used to
confirm connectivity between the Switch and the remote device.
<ipaddr> - Specifies the IP address of the host.
times <value 1-255> - The number of individual ICMP echo
messages to be sent. The maximum value is 255. The default is 0.
timeout <sec 1-99> - Defines the time-out period while waiting for a
response from the remote device. A value of 1 to 99 seconds can
be specified. The default is 1 second.
Pinging an IP address without the times parameter will ping the
target device an infinite amount of times.
None.
From
------------------
Serial Port (PROM)
10.53.13.94
58
User
---------------
Unknown
Anonymous