D-Link xStack DGS-3300 User Manual page 288

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config route redistribute dst ospf src
Purpose
Syntax
Description
Parameters
Restrictions
Routing information source − RIP: the Static Route table, and the Local interface routing information. Routing information will
be redistributed to OSPF. The following table lists the allowed values for the routing metrics and the types (or forms) of the
routing information that will be redistributed.
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
To configure route redistributions:
Used configure route redistribution settings for the exchange of RIP
routes to OSPF routes on the Switch.
config route redistribute dst ospf src [static | rip | local]
{mettype [1 | 2] | metric <value 0-65535>}
Route redistribution allows routers on the network − that are
running different routing protocols to exchange routing information.
This is accomplished by comparing the routes stored in the various
router's routing tables and assigning appropriate metrics. This
information is then exchanged among the various routers according
to the individual routers current routing protocol. The switch can
redistribute routing information between the OSPF and RIP routing
protocols to all routers on the network that are running OSPF or
RIP. Routing information entered into the Static Routing Table on
the local switch is also redistributed.
src [static | rip | local] − Allows the selection of the protocol of the
source device.
mettype − allows the selection of one of the methods for calculating
the metric value.
•
Type-1 calculates the metric (for RIP to OSPF) by adding the
destination's interface cost to the metric entered in the Metric
field.
•
Type-2 uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
metric <value 0-65535> − Allows the entry of an OSPF interface
cost. This is analogous to a Hop Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Route Source Metric
RIP 0 to 16777214
Static 0 to 16777214
Local 0 to 16777214
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2
285