D-Link xStack DGS-3300 User Manual page 315

Layer 3 stackable gigabit ethernet switch xstack dgs/dxs-3300 series
Hide thumbs Also See for xStack DGS-3300:
Table of Contents

Advertisement

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
DGS-3324SRi:4#create pim crp group 231.0.0.1/32 rp Trinity
Command: create pim crp group 231.0.0.1/32 rp Trinity
Success.
DGS-3324SRi:4#
delete pim crp
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To delete an IP interface from becoming a Candidate RP on the Switch:
DGS-3324SRi:4#delete pim crp group 231.0.0.1/32
Command: delete pim crp group 231.0.0.1/32
Success.
DGS-3324SRi:4#
config pim crp
Purpose
Syntax
Description
Parameters
To disable the Switch in becoming a possible candidate to be the
Rendezvous Point (RP).
delete pim crp group <network address>
This command remove the switch's status of Candidate RP. This
command is for PIM-SM configurations only.
group <network_address> - Enter the multicast group address for
this switch to be removed from being a Candidate RP. This address
must be a class D address.
Only administrator-level users can use this command.
To configure the Candidate RP settings that will determine the RP.
config pim crp {holdtime <value 0-255> | priority <value 0-255>
| wildcard_prefix_cnt [0 | 1]}
This command will configure parameters regarding the Candidate
RP on the Switch, including hold time, priority and wildcard prefix
count. This command is for PIM-SM configurations only.
holdtime <value 0-255> - This field is used to set the time
Candidate RP (CRP) advertisements are valid on the PIM-SM
enabled network. If CRP advertisements are not received by the
BSR within this time frame, the CRP is removed from the list of
candidates. The user may set a time between 0 - 255 seconds with
a default setting of 150 seconds. An entry of 0 will send out one
advertisement that states to the BSR that it should be immediately
removed from CRP status on the PIM-SM network.
priority <value 0-255> - Enter a priority value to determine which
CRP will become the RP for the distribution tree. This priority value
will be included in the router's CRP advertisements. A lower value
312

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xstack dxs-3300 series

Table of Contents