Settings in Key Operator Mode
Setting
26
Stop key function
27
Auto select of Booklet copy
28
E.K.C. password
29
Arrow key change Image shift
30
Exit direction of 1 sheet
31
An interruption suspended way
32
E.K.C. password input timing
33
Key click sound (No paper/
JAM)
34
Reserve copy function
35
Scan stop by a pull out tray
36
Change page no. pos. (booklet)
37
Timer prevents print
48
Bookmark
* Initial setting
Di5510/Di7210
Function
When the [Stop] key on the control panel is
pressed, the copy job is either canceled or only
interrupted:
JOB momentary stop* / JOB cancel
Enabling the "Folding" or "Stapling & Folding"
function enables the booklet function:
Automatic selection* / Non Automatic
selection
Length of the E.K.C. password
8 digits* / under 8 digits
Interval for image shift
Decimal point OFF 1 step-1mm* / Decimal point
ON 1 step-0.1 mm
Single copies are output with:
Face down* / Face up
Pressing the [Interrupt] key on the control panel
interrupts the current copy job:
Division of a number of copies* /
During of a number of copies
The access authorization by input of the user
password runs out.
Panel reset timer* / complete job
Signal tone for low paper or paper misfeed.
OFF / 3 seconds* / 5 seconds/ 10 seconds
Automatically switch to the next cleared job.
Reserve copy by folder select* / Reserve copy
by original set
Pulling a paper tray out interrupts the scanning of
the original.
ON* / OFF
Page numbers for booklets are placed
automatically on the outside.
OFF* / ON
Specifies the period required after a copy job
before a print job can be started.
OFF / 15 seconds / 30 seconds * / 60 seconds /
90 seconds
Specifies whether a bookmark is only valid for the
active copy job or remains active after that.
ON (every job disabled)* / ON (not every job
enabled) / OFF
7
7-53