Table of Contents
Advertisement
Applications
4
Specify the file margin values for the edges. Confirm your input by
pressing [OK].
?
What are the [Front], [Back] and [Both Sides] keys for?
§
Use these keys to specify the side for the settings will apply, i.e. the
front, back or both sides. The settings [Back] and [Both Sides] are
only available when making two-sided copies.
§
If you have selected "Reduce & Shift", the [Both Sides] key is not
available. First set the edges for the front side. This value is also
used for calculating the reduction ratio. Then you can specify a
value for the back side. This does not change the reduction ratio.
?
What are the [Up Shift], [Down Shift], [Left Shift] and [Right Shift]
keys for?
§
Press one of these keys. Then enter a value to shift the print area
in the corresponding direction. The settings for the edges can be
combined together.
?
When is the [Page Space] key enabled?
§
The [Page Space] key is only available when the "Booklet" or
"Image Repeat (Repeat 2)" application is enabled. The page
space determines the space left between the two pages on a copy.
5
Confirm your input by pressing [OK].
6
Change any other application settings. Confirm your settings by
pressing [OK].
The basic options are displayed again.
7
Change any other necessary system settings. Use the 10-Key Pad to
set the number of copies.
8
Load the originals
H
into the EDH
H
on the original glass.
9
Press the [Start] key on the control panel to start the scanning cycle.
The copies are printed automatically after the scanning cycle.
Di5510/Di7210
5
5-49
Advertisement
Table of Contents
