Konica Minolta Di5510 Advanced Information page 422

7
Setting
13 EDH AMS
14 Select tray when APS cancel
15 Platen original size detect
16 EDH original size detect
17 Platen original size detect.
SMALL
18 Rotation
19 Staple mode reset-function
20 JOB offset operating
21 Continuation print
22 Key click sound
23 Indication time
24 Energy saver screen
25 Start key latch function
* Initial setting
7-52
Settings in Key Operator Mode
Function
Automatically enables the AMS feature when an
original is loaded into the EDH:
OFF/ ON*
The following paper tray is used if the APS function
is disabled:
APS preferential tray* / Tray 1 / Tray 2 / Tray 3 /
Tray 4 / Bypass
Original sizes that are detected when placed on
the original glass:
AB series* / Only A series / Full-image Area /
Inch series
Original sizes that are detected when loaded into
the EDH.
AB series* / Only A series / Full-image Area /
Inch series
Smallest original placed on the original glass that
can be detected automatically.
A5R* / B6R / 5.5 × 8.5R
When rotation is on, this function is enabled:
ON - Always* / ON - APS / AMS only / ON - APS
/ AMS / Reduce only
The "Staple" function is reset when the copy job
completes:
OFF* / ON
More than one reserved copy jobs are output with
offset.
OFF* / ON
More than one reserved copy jobs are output
automatically in sequence.
OFF* / ON
Acoustic signal when a key on the touch screen is
pressed.
OFF* / ON
Time after which a new display appears.
3 seconds* / 5 seconds
The energy saving function will be enabled when
the [Energy Saver] key on the control panel is
pressed:
Auto shut off mode* / Energy save mode
Auto copy start after warm-up time.
OFF* / ON
Di5510/Di7210