Procedure 22 Install Isl In Dedicated Mode; Isl Installation; Procedure 23 Install Isl In Shared Mode - Nortel 1000 Installation And Commissioning Manual

ISL installation

Use
in dedicated mode. Use
189)
Modem paths must have individual configurations: route data blocks, trunks,
and routes.
Install ISL in dedicated mode (digital and analog)
DTI or PRI should already be up and running.
Procedure 22
Install ISL in dedicated mode
Step
1
2
3
4
5
Install ISL in shared mode
DTI or PRI should already be up and running.
Procedure 23
Install ISL in shared mode
Step
1
2
Copyright © 2003-2007, Nortel Networks
.
Note 2: Forced Data Terminal Ready (DTR) automatically reinitiates a
dropped hot line call.
Procedure 22 "Install ISL in dedicated mode" (page 189)
to install ISL in shared mode.
Action
In LD17, configure ISL for dedicated mode.
USR = ISLD
ISLM = Number of trunks handled by this D-channel (1-382)
In LD16, configure the Route Data Block to map out the software
parameters for these trunks.
Install the modem with leased line functionality.
In LD14, reassign old trunks to the routes just built in LD16.
In LD16, out the old DTI route. A separate Route Data Block should
be built for Leased Line, or to accommodate the dialing plan for a
dedicated modem.
Action
In LD14, remove the PRI trunks.
In LD17, configure ISL for dedicated mode.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Procedure 23 "Install ISL in shared mode" (page
—End—
ISL installation 189
to install ISL