Nortel 1000 Installation And Commissioning Manual page 214

214 1.5 Mb PRI implementation
Prompt Response
- LAPD YES (NO)
- - T23 1-(20)-31
- - T200 2-(3)-40
- - N200 1-(3)-8
- - N201 4(260)
- - K 1-(7)-32
LD 15 - Defining a PRI customer
Prompt Response
REQ: NEW
CHG
TYPE: NET
CUST
0-99
0-31
xxxx
LDN0
AC2
NPA
NXX
INTL
SPN
LOC
Copyright © 2003-2007, Nortel Networks
.
Description
Change LAPD parameters. Enter carriage return if timers
are to be left at default. The following timers are prompted
only if LAPD is set to YES. (They can all be left at default
during initial setup.)
Interface guard timer checks how long the interface takes to
respond. In units of 0.5 seconds (default 20 = 10 seconds).
Retransmission timer in units of 0.5 seconds (default 3 =
1.5 seconds).
Maximum number of retransmissions.
Maximum number of octets in information field.
Maximum number of outstanding unacknowledged frames
(NAKS).
Description
Add new data.
Change existing data.
Networking Data.
Customer number
Range for Large System, Call Server 1000E, and Media
Gateway 1000E
Range for Small System, Media Gateway 1000B
Listed Directory number 0 must be defined for ISDN PRI
DID service.
The length of LDN0 determines the number of trailing digits
translated as the dialed DN on PRI DID routes.
Up to seven digits can be entered if DNXP option 150 is
equipped. Otherwise, up to four digits can be entered.
ESN Access Code 2. Enter incoming ISDN call types
(NARS network translation types) for which AC2 must be
inserted when INAC = YES in LD 16.
Multiple responses are allowed. Prompted only if NARS
is equipped. If a NARS call type is not entered here, it is
defaulted to AC1.
E.164 National.
E.164 Subscriber.
International.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007