Remove The Nt6D11Ab, Nt6D11Ae, Nt6D11Af Dch - Nortel 1000 Installation And Commissioning Manual

86 DCH installation
5
6
7
8
9

Remove the NT6D11AB, NT6D11AE, NT6D11AF DCH

Use
(page 86)
a Large System.
Procedure 2
Remove the NT6D11AB, NT6D11AE, NT6D11AF DCH
Step
1
2
3
4
5
6
7
8
Copyright © 2003-2007, Nortel Networks
.
Install the DCHI card into the assigned shelf and slot.
Connect DCHI port J2 to the NT8D72AB or NT8D72BA PRI port J5
with a QCAD328A cable.
Set faceplate toggle switch to ENABLE.
Coordinate the start-up and verification of the DCHI with the start-up
of the PRI.
Enable the DCHI card using LD 96, command ENL DCHI N.
Procedure 2 "Remove the NT6D11AB, NT6D11AE, NT6D11AF DCH"
to remove the NT6D11AB, NT6D11AE, NT6D11AF DCH from
CAUTION
The NT6D11AB, NT6D11AE, NT6D11AF DCH must be software
disabled before it is hardware disabled, or initialization will occur.
Action
Disable the NT6D11AB, NT6D11AE, NT6D11AF DCHI using LD 96,
command DIS DCHI N.
If asynchronous port J1 is enabled, it must also be software disabled,
using LD 37, or initialization will occur.
If the circuit pack is being completely removed, not replaced, remove
data from memory.
Determine the cabinet and shelf location of the card to be removed.
Set faceplate toggle switch to DISABLE.
Disconnect NT6D11AB, NT6D11AE, NT6D11AF DCHI cables.
Remove NT6D11AB, NT6D11AE, NT6D11AF DCHI card.
Pack and store the card.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
—End—